Embarking on a driveway upgrade starts with ordering the correct kit. Confirm your VIN matches the part number stamped on every Geely Car Metal Rear Bumper to avoid mid-project surprises. Once the brown truck drops the big box, inventory the hardware: eight M10 flange bolts, four rivnuts, two wiring looms, and of course the gleaming Geely Car Metal Rear Bumper itself.

Begin by chocking the front wheels and raising the rear on jack stands. Remove the factory plastic cover by releasing eight pushpins and two 10 mm bolts. The exposed crossmember now awaits the Geely Car Metal Rear Bumper, but first test-fit the new unit to ensure sensor wires reach their plugs. A dry run prevents scratches on the fresh powder-coat of the Geely Car Metal Rear Bumper.

Next, install the supplied rivnuts using a hand riveter. These threaded inserts provide the anchor points that keep the Geely Car Metal Rear Bumper aligned under impact. Torque each M10 bolt to 45 N·m in a crossing pattern, just like lacing a wheel, to avoid stressing any single corner of the Geely Car Metal Rear Bumper.

Wiring comes next. Route the license-plate light harness through the rubber grommet in the trunk floor, then snap the connector into the Geely Car Metal Rear Bumper loom. If your trim level includes parking sensors, pop each one into the pre-drilled holes on the Geely Car Metal Rear Bumper until you hear a confident click. A quick scan with a diagnostic tool confirms every sensor talks to the car’s brain through the Geely Car Metal Rear Bumper interface.

Lower the car and admire the stance. The Geely Car Metal Rear Bumper sits 15 mm closer to the ground than the original cover, giving a subtle performance look without scraping steep driveways. Apply painter’s tape along the seams and run a bead of automotive-grade sealant to stop water from sneaking behind the Geely Car Metal Rear Bumper during monsoon season.

Take a 20-mile shakedown cruise, listening for rattles. The Geely Car Metal Rear Bumper should remain silent, a testament to tight tolerances and foam isolators. When you return home, wash the bumper with pH-neutral soap to remove fingerprints, then stand back and snap photos for the forum. Nothing beats the satisfaction of seeing your own reflection in the flawless finish of a freshly installed Geely Car Metal Rear Bumper.